Mitsubishi Lancer Evolution 

Splitter Installation Instructions 

http://www.autovation.net

  

Step 2:  Installing splitter to front bumper cover     

<== Continued from Page 1

 Snip the (15) holes to make them slots  and install splitter mounts using ( 14) self tapping screws  

Center the mounts using the center hole in bumper cover.  Make sure both ends of splitter overhang bumper cover the same amount  

 

Using pliers/channel lock/etc, tweak mounting ears so that the splitter mount halves are even & splitter is pointing parallel to ground or  slightly down.   Squeeze halves together & reinstall (15) Phillips head bolts  

            

Install splitter to splitter mount using ½” Allen head bolts & lock nuts. Install center brackets using ( 4) ¾” Allen head bolts & lock nuts for inner bracket and ( 4)  ½” Allen head bolts & lock nuts for outer bracket - Press splitter halves together before tightening for better fit.

 

 

Install splitter brace to splitter – Measure 8 ½” from inner edge of mesh opening  & center fore/aft – Drill hole & bolt on  

 

Reinstall bumper to car in reverse order of removal  

Once installed & back on ground, adjust splitter to a slight down angle,  approximately 2 degrees

 

Done!

 

 

 

 

WARRANTY /DISCLAIMER

 

AutoVation Technologies, Inc. is not to be liable for any consequential, special or contingent damages, expense, or injury arising directly or indirectly from any defect in its goods or from the use of any goods, defective or otherwise. AutoVation Technologies, Inc. and its affiliates will in no way be held responsible for any damages to any vehicle, persons or property for any reason whatsoever.  The installer/owner assumes all risks involved with the installation and use of these products.  The items represented by AutoVation Technologies, Inc. are for off-road use only and no warranty is either EXPRESSED or IMPLIED.  No warranty or representation is made as to these products ability to protect the user from injury or death.   The user shall determine the suitability of these products and assume all risks and responsibility in connection with their use.  Automobile racing is a dangerous activity and the user shall assume all risk and responsibility.  Installation of an item is an acknowledgement and acceptance of the terms of this disclaimer. Any warranties implied by law are limited in duration to the duration of this warranty.