Mitsubishi Lancer Evolution  Splitter Installation Instructions  http://www.autovation.net

   

NOTE:  Click on any picture for larger image

Remove (1) 10mm bolt in wheel well/fender area and Phillips head plastic clips per side from wheel well/fender area

Remove (2) 10mm bolts (2) plastic mounting clips from upper radiator area

 

Unhook intercooler sprayer tube and separate bumper from fender by pulling down (do both sides)

 

 

 Bumper is now loose, pull forward to remove    

 

Remove (15) Phillips head bolts from lower back side of bumper cover and factory lower lip will now come off

Continued on Page 2 ==>

             

 

 

 

WARRANTY /DISCLAIMER

 

AutoVation Technologies, Inc. is not to be liable for any consequential, special or contingent damages, expense, or injury arising directly or indirectly from any defect in its goods or from the use of any goods, defective or otherwise. AutoVation Technologies, Inc. and its affiliates will in no way be held responsible for any damages to any vehicle, persons or property for any reason whatsoever.  The installer/owner assumes all risks involved with the installation and use of these products.  The items represented by AutoVation Technologies, Inc. are for off-road use only and no warranty is either EXPRESSED or IMPLIED.  No warranty or representation is made as to these products ability to protect the user from injury or death.   The user shall determine the suitability of these products and assume all risks and responsibility in connection with their use.  Automobile racing is a dangerous activity and the user shall assume all risk and responsibility.  Installation of an item is an acknowledgement and acceptance of the terms of this disclaimer. Any warranties implied by law are limited in duration to the duration of this warranty.